Advertisement
WARNING: TO AVOIDSERIOUSINJURY, B EFOREPERFORMING ANY SERVICEOR
ADJUSTMENTS:
, Depress clutch/brake pedal fully and set parking brake.
, Place attachment clutch in "DISENGAGED" position.
4. Turn ignition key to "STOP" and remove key.
5, Make sure the blades and all moving parts have completely stopped.
6. Disconnect spark plug wire from spark plug and place wire where it cannot come
in contact with plug.
TO REMOVE
MOWER
1. Place attachment
clutch in "DISEN-
GAGED" position.
2. Lower attachment lift lever to its lowest
position.
3. Disengage belttension rod (K)from lock
bracket (L).
CAUTION: Belt tension rod is spring
loaded, Have a tight grip on rod and release
slowly.
4. Remove mower belt from electric dutch
pulley (M).
5. Disconnect front link (E) from mower -
remove retainer spring and washer.
6. Go to eitherside of mower and disconnect
mower suspension arm (A) from chas-
sis and rear lift link (C) from rear mower
bracket (D) - remove retainer springs and
washers.
7. Goto otherside of mower and disconnect
the suspension arm and rear lift link.
_lb CAUTION: After rear liftlinks are discon-
nected, the attachment lift leverwill bespring
loaded, Have a tight grip on lift lever when
changing position of the lever,
8. From right side of mower, disconnect
anti-sway bar (S) from right rear mower
bracket (D) - remove retainer spring and
washer and pullmower toward you until
the bar falls from the hole in bracket.
9, Turn tractor steering wheel to the left as
far as it will go,
10. Slide mower out from under right side of
tractor.
TO INSTALL
MOWER
Follow
procedure
described
in "INSTALL
MOWERAND
DRIVE BELT" in the Assembly
section of this manual.
26
Advertisement
