Summary of Contents for DEK 2-Way Feed Chipper/Shredder
Page 1
Serial #: Model #: DEK® is registered trademark of GXi International, Clayton, NC 27520 USA No part of this publication can be printed or copied without written permission. Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 1 ofll...
Page 2
Do not put hands and feet near rotating parts or in the feed- ing chambers and discharge opening. Contact with the rotating impeller can amputate fingers, hands, and feet. Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 2ofll...
Page 3
Starter Lawn tractor or ATV trailer hitch (maximum Clean out tow speed is 15 mph). and blade access hatch Dischar Chute Hardware bag, safety de- vices and chip collection Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 3ofll...
Page 4
15. Muffler and engine become hot and can cause a burn. Do debris. not touch. Allow machine to cool at least 5 minutes before 16. Never pick up or carry machine while the engine is running. storing. Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 4ofll...
Page 5
Chip collection bag with the locking cotter pin. • Wrench for assembly of the chute and funnel • Hardware bag with a spare blade 8. Re-connect the spark plug wire Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 5ofll...
These labels warn you of potential hazards that can cause seri- ous injury. Read them carefully. If a label comes off or becomes hard to read, contact your DEK dealer for a replacement. SAFETY INFORMATION DEK products are designed to give safe and dependable service if operated according to instructions.
This noise is caused by the flails and fingers, which are part of the shredding mechanism, and it should be expected until the impeller reaches full speed. Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 7ofll...
Page 8
Wipe equipment with an oiled rag to prevent rust. Refer to engine manual for correct engine storage instruc- tions Store unit in a clean, dry area. Do not store next to corro- sive materials such as fertilizer. Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 8ofll...
Also, make sure to remove an equal amount from each blade and torque to 250 - 300 in. lbs. NOTE: Make certain blades are reassembled with the sharp edge facing upward. Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 9ofll...
Chipper blade dull. Replace chipper blade or see your authorized service dealer. NOTE: For repairs beyond the minor adjustments listed above, contact your nearest authorized service dealer. Rev: 1/23/2008 DEK® is exclusively distributed by GXi International, LLC 10 of 11...
Page 11
The follow- ing instructions and procedures must be followed in order to keep the emissions from your DEK engine within the emission standards. Maintenance, replacement, repair of the emission control devices and systems may be performed...
Need help?
Do you have a question about the 2-Way Feed Chipper/Shredder and is the answer not in the manual?
Questions and answers
how to remove shaft bearings on DEK ch1-9m woodchipper. Bearing destroyed. How to remove rounded "C" clip?