Numeric Error Codes - Lenovo ThinkPad T430u Hardware Maintenance Manual

Hardware maintenance manual - thinkpad t430u
Hide thumbs Also See for ThinkPad T430u:
Table of Contents

Advertisement

Numeric error codes

Table 1. Numeric error codes
Symptom or error (beeps, if any)
0177
Bad SVP data, stop POST task.
0183
Bad CRC of Security Settings in EFI Variable. Enter
ThinkPad Setup.
0188
Invalid RFID Serialization Information Area.
0189
Invalid RFID configuration information area—The
EEPROM checksum is not correct.
0190
Critical low-battery error
0191
System Security—Invalid Remote Change requested.
0199
System Security - Security password retry count
exceeded.
0251
System CMOS checksum bad— Default configuration
used.
0271
Real Time Clock Error - Check Date and Time settings.
2000
ThinkVantage Active Protection sensor diagnostics failed.
2100
Initialization error on HDD0 (Main HDD).
2110
Read error on HDD0 (Main HDD).
2200
Machine Type and Serial Number are invalid.
2201
Machine UUID is invalid.
1802
Unauthorized network card is plugged in—Turn off and
remove the Mini PCI network card.
(two short beeps)
1820
More than one external fingerprint readers are attached.
Power off and remove all but the reader that you set up
within your main operating system.
36
Hardware Maintenance Manual
FRU or action, in sequence
System board.
1. Run ThinkPad Setup.
2. Press F9 and then press Enter to load the default
setting. Press F10 and then press Enter to restart
the system.
System board.
System board.
1. Charge the battery pack.
2. Battery pack.
1. Run ThinkPad Setup, and then save current
setting by pressing F10.
2. System board.
Run ThinkPad Setup to clear the error.
1. Charge the backup battery for more than 8 hours
by connecting the ac power adapter.
2. Replace the backup battery and run ThinkPad Setup
to reset the time and date.
Run ThinkPad Setup to reset the time and date.
Run ThinkPad Setup.
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
System board.
System board.
1. Remove the Mini PCI network card.
2. System board.
There are more than one external fingerprint readers.

Advertisement

Table of Contents
loading

Table of Contents