Table of Contents
Advertisement
Storing A Telephone Number To The Call
List
The number of dial locations (10, 20, 30, 40,
or 50) available is set through radio programming.
The maximum number of digits stored in any
location is 14. The user may dynamically add
phone numbers to the call list by following these
steps:
1.
Enter the phone number, then
followed by
2.
Enter the two digit storage location for
the number (00 to 50).
The new phone number is now added to the
call list at the specified location.
Recalling calls from the call list
Each pre-stored call number has a
corresponding phone number. To dial the phone
number, select the 2 digit call number and press
. Alternately, the user can scroll through the
,
.
call list using the
through the list.
Simplex Operation
The user can choose to terminate duplex
operation and still maintain the interconnect call in
progress by pressing
This key sequence toggles between simplex and
duplex operation.
*/System Key usage
The
/System ramp button is used in
multiple contexts. When pressed while in monitor
mode (i.e. radio is not in a special or interconnect
call) the radio ramps through available systems in
one direction.
If
/System is pressed, system ramping takes place
in the opposite direction. If this key is pressed
after any key other than
returned.
key to scroll forward
followed by
.
followed by
the
is
21
Advertisement
Table of Contents
