Table of Contents
Advertisement
4036-501
Adjusting the Position of Full Rate/Half Rate Carriages
1.
2.
3.
Note: When the half rate carriage rests against the paper stop (2 pieces), a gap may be
generated on either the In or Out side stopper. Before you move to the next step, loosen
the two (2) screws on the rear pulley-capstan, and again tighten the screws with the
carriage pushed against the paper stop on either the In or Out side.
4.
5.
6.
4-6
Service Manual
Remove the flatbed center platen glass plate.
Loosen the two (2) screws that secure the full rate carriage.
Move the half rate carriage until it rests against the stopper.
While the half rate carriage rests against the steppers, move the full rate carriage
until it rests against the right side frame.
Tighten the two (2) screws in the full rate carriage.
Mount the flatbed center platen glass plate.
Advertisement
Table of Contents
