Infinity kappa series Instructions page 3

I
NSTALLATION
Figure 4. Mounting the 62.5i with the grille.
Figure 5. Mounting the 62.5i in a 165mm
speaker location.
FOAM GASKET
INTERMOUNT RING
Figure 6. Mounting the 62.5i in a standard
speaker location.
1
2
FOAM GASKET
Figure 7.Tweeter level adjustment.
PUSH BUTTON
kappa series
INTERMOUNT III MOUNTING RINGS
The Kappa 62.7 and 63.7 speakers are packaged
with two different speaker adaptor rings. The
rings will allow the speakers to be installed into
various factory 6, " 6-1/2" and 6-3/4" openings. See
Figure 5. The metal ring can be mounted in many
European vehicles, Japanese vehicles or vehicles
with 6" speaker locations. The plastic ring can be
mounted in many vehicles using 6-3/4" speaker
locations or three-point mounting frames.
UNIPIVOT ™ ROTATING TWEETER
In order to rotate the tweeter on select Kappa
speakers, (1) push the tweeter post inward
and (2) then rotate. Once in position, release
the tweeter to lock in position (Figure 6). This
feature is only available on the Kappa 52.7, 62.7,
692.7 and 682.7cf speakers.
TWEETER LEVEL ADJUSTMENT
All Kappa series multielement speakers are
equipped with an adjustable tweeter level. On
all two-way speakers, slightly twist the tweeter
faceplate to either the +3dB or 0dB position
(Figure 7). All three-way speakers have a push
button to adjust the tweeter level between the
+3dB and 0dB setting (Figure 7). Adjust to
personal preference.
C
ONNECTIONS
Figure 8. Connecting an in-line crossover to a
62.7i and an amplifier output. Other speaker
models are connected in a similar way.
Tweeter
terminals
Yellow Green
on top
Woofer
White Blue
terminals
on bottom
NOTE: The positions
shown here for the
polarities may not
resemble the exact
connections in every
installation. However,
in every case, the
larger terminal is the
positive (+) connection.
Red Black