Panasonic HDC-HS80P Owner's Manual page 93

• Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
• Inserting/removing an SD card
O Insert the battery until it clicks and locks.
• Charging the battery
O DC input terminal
O Connect the AC adaptor to the DC input
terminal.
I_ Connect the AC cable to the AC
adaptor, then the AC outlet.
• The status indicator will flash red at an
interval of 2 seconds, indicating that
charging has begun.
It will turn off when the charging is
completed.
AcCess lamP [ACCESS] O
• When this unit is accessing the SD
card or built-in memory, the access
!amp !ights UP,
• Check that the access lamp has gone off.
1) Open the SD card cover and insert
(remove) the SD card into (from) the
card slot Q.
• Face the label side _ in the direction
shown in the illustration and press it
straight in as far as it will go.
• Press the center of the SD card and then
pull it straight out.
2) Securely close the SD card cover.
• Securely close it until it clicks.
13
VQT3J15