Panasonic Palmcoder Palmsight PV-L579 Operating Instructions Manual page 12

Supplying Power
- DC Power Cable _
POWER Lamp
VCR DC OUT Connector
DC IN
Connector
1
2
[]
Connect AC Adaptor VCR DC OUT
to Camcorder DC IN with supplied
DC Power Cable.
Plug in AC Adaptor.
POWER Lamp lights.
Notes:
• AC Adaptor cannot power Camcorder while
charging Battery.
• When not in use, unplug AC Adaptor from AC
outlet. (Adaptor uses 1.2 W of electricity while
plugged in.)
_.-- CAUTION:
This unit will operate on 110/120/220/240V AC. An AC plug adaptor may be
required for voltages other than 120V AC. Please contact either a local or foreign
electrical parts distributor for assistance in selecting an alternate AC plug.
We recommend using the accessory power plug adaptor (VJSS0070) in an area
which has special AC outlets.
I[If;.lll :P_'li (:] iv|l,_o] i[= | I(,._ | [o] i_11 !
DC IN
Connector
Cigarette Lighter
Socket (12V)
Car Battery Cord
(optional)
12
Cigarette
Lighter Plug
1
2
Connect PV-C16 C_r Battery Cord
(optional) to Camcorder DC IN.
A Start engine first.
B Plug Car Battery Cord into
Cigarette lighter socket.
• If Car Battery cord fuse needs
replacing, use exact current rating
(in amps).
Notes:
• This cord only works in vehicles equipped
with DC 12V (negative ground) battery.
Check with your car/truck dealer. Use
only specified car battery cord.
• To avoid blowing the car battery cord
fuse, do step 2 in the proper order.
• Running vehicles must be well ventilated.
• When not in use, disconnect cigarette
lighter plug.