Control Operation; Power Button; Volume (Vol) Buttons; Channel Change Features - Panasonic CT-20S2S Operating Instructions Manual

Control Operation
Power
- Press the POWER button to turn ON. Press
again to turn OFF.
POWER
Volume- Press the VOLUME (VOL) LEFT or RIGHT
button for desired listening level (while On Screen Menus
are not displayed).
Channel Change - (Twooptions)
Option 1.
Press the CHANNEL (CH) UP or DOWN button to
sequentially scan through programmed channels
(while On Screen Menus are not displayed).
Located On Remote Control
Selects Next
Higher Channel
Selects Ne
Lower Channel
Located On Remote Control
Decreases
Volume Level
Increases
Volume Level
Helpful Hints:
• Helpful information will display On Screen
momentarily when Receiver is first turned on and
when the channel is changed.
When using keyboard entry for channels 10, 11 and
12 in the CABLE mode there is a slight delay before
channel change because of the capability of tuning
cable channels 100 to 125.
If you do not receive channels above 13, confirm the
type of signal at ANT Input (TV or Cable) and set the
TV or Cable Tuning Mode accordingly. (Refer to
Set-Up Feature, Antenna selection.)
Option 2.
Press two digits on keyboard (Example press 0, then
5 for channel 05). For channels over 99, press three
digits on keyboard.
1 2 3
© © ©
4 5 6
(5 (5
o
Mute
- Press the MUTE button to quickly reduce
sound level (Mute will appear on screen). Press again to
restore sound.
MUTE