Advertisement
The operation of any lawn mower
can result in
foreign objects thrown
intothe eyes,whichcanresultin
severe eye damage.
Always wear safety
glasse6 or eye shields while operating your
lawn mower or performing any adjustments
or repairs. We recommend a wide vision
safety mask over spectacles or standard
safety g bsses.
HOWTO USEYOUR LAWN MOWER
ENGINE SPEED CONTROL
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
_,CAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence controlbar which
mcluires the operatorto be positioned
behind the lawn mower handle to start and
operatethe lawn mower.
TO ADJUST CUTTING HEIGHT
• Raise wheels for low cut and lower wheels
forhighcut.
• Adjustcuttingheightto suit your require-
merits. Medium pos_ionis best for most
lawns.
• To change cuttingheight,squeeze adjuster
lever toward wheel. Move wheel up or
down to suityour requirements. Be sure all
wheels are in the same setting.
NOTE: Adjuster is propedy positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Lower wheels for
high cut
Plate tab
Raise wheels for low
cut
NOTE: Your lawn mower has been
shipped ready for mulching operation.
To
convert to discharging
operation,
you
must install the discharge
deflector
attachment
included with your mower.
TO CONVERT TO DISCHARGING
MOWER
Your mower is shipped ready to be used
as a mulcher. To convert to bagging or
discharging:
• Lift discharge guard and remove
mulcher plate.
• Mower can now be used for side
discharge or optional grass catcher can
be attached.
• To return to mulching operation, simply
reinstall mulcher plate as shown.
ACAUTION:
Do not run your lawn
mower without discharge guard,
approved grass catcher or mulcher plate
in place.
Housin
opening
,-Hooks
Mulch
Hinge
rod
BEFORE STARTING ENGINE
OIL
Your lawn mower is shipped without oil in the
engine.
• Be sure mower is level and area around oil
fin is dean.
• Remove engine oil cap and fillto the full
line on the dipstick.
NOTE:
Allow oil to settle down into
engine for accurate
dipstick reading.
• Engine holds 20ozs.
of oil. For type and
grade of oil to use, see fl_NGIN_' in
Maintenance section of this manual.
• Pour oil slowly. Do not over fiB.
• Check oil level before each use. Add oil if
needed. Fill to full line on dipstick.
• To read proper level, tighten engine oil cap
each time.
• Reinstall engine oil cap and tighten.
• Change the oil after every 25 hours of
operation or each season. You may need
to change the oil more often under dusty,
dirtycondtions.
6
Advertisement
