SERVICE AND ADJUSTMENTS
TO ADJUST
STEERING
WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheets are positioned straightforward,
remove steer-
mg wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL
TOE-IN!CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor.
If damage has Occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
TO REMOVE
WHEEL
FOR REPAIRS
(See Fig. 24)
o
Block up axle securely.
.
Remove axte cover, retaining ring and washersto allow
wheel removal (rear wheel contains a square key - Do
not lose).
•
Repair tire and reassemble.
•
On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key.
-
Replace washers and snap retaining ring securely in
axle groove.
•
Replace axle cover,
WASHERS
RETAINING
RING
AXLE COVER
FiG. 24
TO START ENGaNE WSTH A WEAK BATTERY
See Fig, 25)
_[_
at__ep
sparks_-flame
I
_a_s
away from bat-
te__p
otection
I
If your battery is too weak to start the engine, it should be
recharged.
If "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT:
YOUR TRACTOR _SEQUIPPEDWlTH
A 12
VOLT NEGATIVE GROUNDED SYSTEM.
THE OTHER
VEHICLE
MUST ALSO
BE A 12 VOLT
NEGATIVE
GROUNDED SYSTEM.
DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES.
TO ATTACH JUMPER CABLES -
Connect each end of the RED cable to the POSITIVE
(+) terminaf of each battery, taking care not to short
against chassis.
.
Connect one end of the BLACK cable to the NEGA-
TIVE (-) terminal of fully charged battery.
*
Connect the other end of the BLACK cable to good
CHASSIS G ROUND, away from fuel tank and battery,
TO REMOVE CABLES, REVERSE ORDER -
.
BLACK cable first from chassis and then from the fully
charged battery.
.
RED cable last from both batteries.
POSITIVE TERMINAL
NEGATIVE
TERMINAL
CHARGED
BATTERY
POSITIVE TERMINAL
NEGATIVE
TERMINAL
FIG, 25
22 •