Table of Contents
Advertisement
TO ADJUST
HANDLE
(See Figs. 18 Thru 20)
Your lawn mower handle can be raised or lowered for your
mowing comfort
Four (4) positions are available: high,
medium high, medium low and low Handles are shipped
mounted in the medium low position.
o
To change from medium low to medium high position,
the upper and lower handle sections will have to be
turned over (See Fig_ t8B)
-
Remove the controls and operator presence control
bar from the upper handle_
•
Remove the starter rope guide from the lower handle°
•
Remove hairpin cotter&
•
Disconnect the lower handle from the handle brackets
(See Fig., 20),
o
Turn the handle over and reassemble
the hairpin
cotters that have been removed,
•
Reassemble the starter rope guide..
o
Reassemble the controls and the operator presence
control bar to the upper handle°
CAUTION:
The operator
presence
control bar must pivot freely to permit
blade brake engagement
when control
bar is released. Do not over tighten the
fasteners
holding the controls to the
upper handle.
o
To change from medium low to high position only the
upper handle section wilt have to be turned over (See
Fig, 't9A).
•
To change from medium low to low position, only the
lower handle section will have to be turned over (See
Fig. 19B).
ENGaNE
ENGINE
SPEED
Your engine speed has been factory set. Do not attempt
to increase engine speed or it may result in personal
injury. If you believe that the engine is running too fast or
too slow, take your lawn mower to an authorized
service
center for repair and adjustment.
CARBURETOR
Your carburetor
has a non-adjustable
fixed main jet for
mixture control
If your engine does not operate properly
due to suspected
carburetor problems,
take your lawn
mower to an authorized
service
center for repair and
adjustment.
SHIPPING POSITION
MED|UM LOW
MEDIUM HIGH
FIG. 18A
FIG, 18B
F
HIGH
\
LOW
\
FIG. 19A
FIG, 19B
SQUEEZE
TO
LOWER HANDLE
HAIRPIN CLIP
HANDLE
BRACKET
FIG. 20
17
Advertisement
Table of Contents
