Connecting To An Antenna; Part Names; Connecting To Video Equipment - Sharp 21J-FH1RU Operation Manual

E2 ANTENNA CONNECTION

Connecting to an antenna

300-ohm 75-ohm
twin-lead impedance
flat feeder converter
(not supplied) (not supplied)
75-ohm
coaxial cable
(round cable)
(not supplied)
Antenna in
Standard DIN45325
plug (IEC169-2)
If your outdoor antenna uses a 75-ohm coaxial
cable with a standard DIN45325 plug (IEC 169-2),
plug it into the antenna jack at the rear of the set.
E3 CONNECTING TO OTHER EQUIPMENTS

Connecting to video equipment

Enjoy playback from a video disc player, VCR or other video equipment by connecting them to
this TV set using the Audio/Video in terminals.
Example of front terminals usage
Yellow : To VIDEO
VCR
White : To AUDIO (L)
Red : To AUDIO (R)
TV
Video Game
Camcorder
To Audio/Video
out terminals
• For playback of monaural audio, connect the external source to the audio input left terminal on the front or rear of the
TV set (MONO) to hear the same sound from both speakers.
• The audiovisual cords required to connect the TV set with video equipment may differ from those shown in the above
diagram. See the operation manual of your video equipment for connection details.
• The above recording and editing connections are for intended solely for personal use and not for the illegal copying of
audiovisual material protected by copyright laws.
Connecting to an antenna via a VCR
TV
TV
VCR
To RF out
terminal
To antenna
in terminal
Antenna in
If your outdoor antenna uses a 300-ohm twin-lead
flat feeder, connect a 300-ohm to 75-ohm
impedance converter and plug it into the antenna
jack at the rear of the set.
Example of rear terminals usage
TV
For Playback
DVD Player
To Audio/
Video out
terminals
To Audio/
Video out
terminals
VCR
For Recording and Editing
Yellow : To VIDEO
To Audio/
White : To AUDIO (L)
Video in
Red : To AUDIO (R) terminals
E4 ACCESSORIES
The following accessories are included with this television.
Remote Control
E5

PART NAMES

TV set
Bottom
!
POWER POWER switch
Turns on and off the main power.
@
Power indicator
Power can be turned on by the remote control when
the indicator is dimly lit.
#
Infrared sensor window
Receives the infrared wave from the remote control.
VCR
$
MENU/PRESET MENU/PRESET button
Tunes the channels.
Used for MENU setup.
Size-AA batteries
To open the door
Using the projection located under the
√
" PULL-OPEN" indication, pull and lift the
door open.
To close the door
Using the projection, lower the door until
closed.
Caution:
• When opening or closing the door, do not insert
your fingers into the gap between the door and
front panel. This may result in an injury.
Door
! @ # $ % ^ &
%
/
Adjusts the volume.
Makes adjustments in PRESET.
^
/
CH
Selects the channels.
Tunes or sets the channels.
&
Video input terminal (AV-2 IN)
Connects to a camcorder, video game, etc.
*
Audio input terminals (AV-2 IN)
Connects to a camcorder, video game, etc.
Operation manual
*
Volume up/down buttons
Channel up/down buttons
CH