Sharp DK-AP8P Operation Manual page 21

■ To insert iPod or iPhone adaptor
1. Open the docking station by sliding out the top cover at the
area marked.
E
ON/STAND-BY SOUND
2. Insert the iPod or iPhone adaptor into unit and connect your
iPod or iPhone.
iPhone (bottom)
Dock connector
iPhone adaptor
iPhone dock
iPhone connector
Caution:
Unplug all accessories from the iPod or iPhone before inserting
it into the dock.
E
ON/STAND-BY SOUND
iPhone
■ To remove iPod or
iPhone adaptor
Insert the tip of a screwdriver ("-"
type, small) into the adaptor hole as
shown and lift upward to remove.
■ iPod or iPhone playback
1
Press the ON/STAND-BY button on the main unit or
touch the ON/STAND-BY pad on the remote control to
turn the power on.
2
Insert iPod or iPhone unit in the dock of main unit.
3
Press the button on the iPod unit or touch the
/ pad on the remote control to start playback.
For iPod touch and iPhone, playback will start by touching
the ENTER pad on the remote control.
iPhone adaptor
■ iPhone playback
●
Sound will only switch from iPhone to the main unit after
authentication process is completed in approximately
10 seconds.
●
Incoming calls will pause the playback and iPhone ringtones
will be heard from the main unit speakers only.
●
Once the calls are answered, the conversation can only be
heard through the built-in iPhone speaker. Turn on the iPhone
speaker or undock the iPhone to start conversation.
DK-AP8P
ENGLISH
iPhone
E-10