Table of Contents
Advertisement
IMPORTANT
SAFETY
INSTRUCTIONS
Your product has been manufectm_
and tested with your safety in mind. However, improper usa can result in potential
electrical shock or fire hazards. To avoid defeating the safeguards that have been built into your new l_oduct, please
read and observe the following safety points when installing and using your new iwoduct, and save them for future refer-
once.
Obsas:ving the simple lnecaudons discussed in this section of the operating guide can help you get many years of enjoy-
n'-z_,z and safe operation that are built into your ne_v product.
1..
Read Instructions
All the safety, and operating
instructions
should be read before the product is operated.
2.
Follow
Instructions
All o.peratlng and use instructions
should be
followed.
3.
Retain Instructions
The safety and operating
instructions
should
be retained
for future reference.
4.
Heed Warnings
All warnings
on the product and in the operat-
ing instnietions
should be adhered
to.
$.
.Clening
Unplug this product from the wall outlet be-
fore-cleaning.
Do not use liquid cleaners or
aerosolcleaners.
Use a damp cloth for clean-
ing.
6..
Water
nnd'Moisturo
Do not use this product near water -- for ex.
amplej near a bath tub, wash bowl, kitchen
sink, or lanndry tub, in a wet basement,
or
ncara
e_vimming pool,
7, - Accessories
Do not place this product on an unstable
cart.
s ,rand, tripod, bxecket'-or table. The product
may fall, causing
serious injury to a child or
adult, and serious damage to the product. Use
only wi_ It cart, stand, tripod, bracket, or ta-
ble recommended
by the manufacturer,
or sold
with the product. Any mounting
of the product
shoul d follow
the manufacturer's
instructions,
and should use a mounting
accessory
recom-
mended by the manufacturer.
8.
Transporting
Product
t
A product and c_t
combina-
_.
tion should be moved with
care. Quick
stops, excessive
force, and uneven surfaces may
cause the product and can com-
eomtm.e e._T _
bination
to overturn.
9.
Attachments
Do not use attachments
not recommended
by
the product manufacturer
as they may cause
hazards.
10.
Ventilation
Slots and openings
in the cabinet
are provided
for ventilation
and to ensure
reliable
operation
of the product and to protect it from overheat-
i_g, and these openings
must not be blocked
or covered.
The openings
should never be
bloelced by piecing
the product on a bed, sofa,
rug, or other similar
surface.
This product
.. should not he placed in a built-in installation
such as a bookcase
or rack unless proper venti-
lation is provided or the' manufacturer's
in-
structions
have bee,, adhered to.
11.
Power Sources
This product should be operated
only from the
type of power source indicated
on the marking
label. If you are not sure of the type of power
supply to your home, consult your product
dealer or local power company.
For products
intended to operate from battery power, or
other sources,
refer to the operating
instruc-
tions.
t
12.
Line-Cord
Polarization
This product is equipped
with a polarized
alter-
eating-current
line plug (a plug having one
blade wider than the other). This plug will fit
into the power outlet only one way. This is a
safety feature. If you are unable to insert the
plug fully into the outlet, try reversing
the
plug. If the plug should still fail to fit, contact
your electrician
to replace
your obsolete
out-
let. Do not defeat the safety purpose of the po-
larized plug.
13.
Power-Cord
Protection
Power-supply
cords should be routed so that
they are not likely to he walked on or pinched
by items placed upon or against
them, paying
particular attention to cords at plugs, conven-
ience receptacles,
and the point where they
exit from the product.
14.
Outdoor
Antenna
Grounding
• If an outside
antenna or cable system
is con-
nected to the product, be sure the antenna or
cable
system is grounded
so as to provide
some protection
against voltage surges and
built-up static charges.
Article 810 of'the Na-
tional Electrical
Code (U.S.A.),
ANSI/NFPA
70 provides
information
with regard to proper
grounding
of the mast and supporting
struc-
ture, grounding
of the lead-in
wire to an an-
tenna discharge
unit, size of grounding
conductors,
location
of antenna-discharge
unit, connection,
to grounding
electrodes,
and
requirements
for the grounding
electrode.
See
figure on next page.
15.
Lightning
"
For added protection
for this product (re-
ceiver) during a lightning
storm, or when it is
left unattended
and unused for long periods of
time, unplug it from the wall outlet and discon-
nect the antenna or cable system. This will pre-
vent damage to the product due to lightning
and power-line
surges.
GA-SAFB
Ill
Advertisement
Table of Contents
