Afc Mode; Time Set - Zenith SENTRY 2 Operating Manual & Warranty

SETUP MENU
AFC MODE
]Purpose
]Lets your TV compensate for variations in broadcast and
cable-TV frequencies.
]Ef y ou are hax4ng difficulty tuning channels, the AFC
MODE may have to be set manually to match your viewing
needs.
Before Using AFC Mode
Connect and turn ON all external equipment, such as cable-
TV decoder, VCR, etc.
NOTE: AFC MODE is not displayed while AUX channel
!Ls b eing used.
F
AUTO SEARCH
FAV. CHANNELS
BAND SELECT
- > AFC MODE
I TIME SET
Selecting AFC Mode
--------4P
AFC MODE
FIXED
PRESS ADJUST
KEY TO CHANGE
AFC Mode Display
To Use AFC MODE
1. AFC MODE display should be shown on the TV if
you followed the "Basic Menu Operation" given in
the "On-Screen Menus" section.
2. Press ADJUST (AI)J) Left/Right to select the
desired mode of operation, as follows:
• FIXED is used to reca.qve "over-the-air" TV stations,
and with many cable TV systems.
• SEARCH is used only when the TV must search to
find the frequency being received, such as when used
with certain VCRs and video game modulators.
When Some Channels Are Not Clear
If some channels are not clem, change the BAND
SELECT. You may have to try different AFC MODE and
BAND SELECT settings until you get a consistently clear
picture, channel-to-channeL Refer to the BAND SELECT
option for details.
TIME SET
Purpose
Sets the clock in the TV to the correct time.
After the time has been set, the current time will appear on
the Channel/Time display whenever the TV is turned on,
the channel is changed, or ENTER (ENT) is pressed.
Power Failm_e Note: The time will have to be reset if power
to the TV is interrupted.
f
AUTO" SEARCH
FAV. CHANNELS
BAND SELECT
AFC MODE
- > TIME SET
Selecting Time Set
TIME SET
PRESS NUMBERS
OR ADJUST KEYS
Time Set Display
To Use TIME SET from Remote Control
1. TIME SET display should be shown on the TV if you
followed the "Basic Menu Operation" given in the
"On-Screen Menus" section.
2. Use the numbered buttons on the remote control to
enter the, current time. Press ENTER. (ENT) to start
the clock.
For example, to set the clock to 6:30, press 6, then
3, then 0; and then press ENTER (ENT). If you
enter an invalid time, such as 14:35 or 2:80, the time
will disappear and you can enter another time.
To Use TIME SET from Control Panel
1. TIME SET display should be shown on the TV if you
followed the "Basic Menu Operation" given in the
"On-Screen Menus" section.
2. Use ADJUST (ADJ) Left/Right to set the time, and
then press ENTER (ENT) to start the clock.
2597_ 7 -- 3