Epson EB-G5200W User Manual page 49

List of Functions
Sub Menu
SNMP g You can make SNMP settings.
Trap IP Address 1/Trap IP Address 2: You can register up to two as the SNMP trap notification destination.
To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a
network expert.
Mail When this is set, you receive an e-mail notification if a problem or warning occurs in the projector. For information on the contents of the sent e-
mail, s "Reading Problem Mail Notification Function"
Mail Notification: You can set whether or not (On/Off) to be notified by e-mail. If this is set to "Off" you cannot set any more addresses.
SMTP Server: You can input the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Port Number: You can display the SMTP server's port number.
The default value is 25. When editing settings from WEB control, you can change the port number by entering a valid number from 1 to 65535.
Address 1 Setting/Address 2 Setting/Address 3 Setting: You can enter the e-mail address
notification when a problem or warning occurs. You can register up to three destinations. You can enter up to 32 single-byte alphanumeric
characters for the e-mail addresses.
AMX Device
When the projector is connected to a network, set this to "On" to allow the projector to be detected by AMX Device Discovery. Set this to "Off" if you
Discovery g
are not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
Projector Name Displays the projector name used to identify the projector when connected to a network.
Reset You can reset all adjustment values for the "Network" menu to their default settings.
To return all menu items to their default settings, see s
*1 When inputting numbers and passwords, the following software keyboards are displayed. Tilt the [h] button on the remote control to move the cursor to
the target key, and then press the [Enter] button. Enter figures by holding down the [Num] button on the remote control, and pressing the numeric
buttons. After inputting, press [Finish] on the keyboard to confirm your input. Press [Cancel] on the keyboard to cancel your input.
Each time this key is
selected, it sets and
changes between
upper case and
lower case letters.
Function
p.111
p.64
Each time this key is
selected, it sets and
changes the symbol
keys for the section
enclosed by the frame.
*1
*1
*1
and the contents of the message to receive
49