Advertisement
TO MOVE FORWARD AND
BACKWARD
The direction and speed of movement
is
controlled by the motion control lever. (J)
1. Start tractor with motion control lever in
neutral
position.
2. Release parking brake.
3. Slowly
move motion control
lever to
desired position.
TO ADJUST MOWER CUTTING HEIGHT
The position of the attachment
lift lever (A)
determines the cutting height.
TO ADJUST GAUGE WHEELS
Gauge wheels are properly adjusted when
they are slightly offthe ground when mower
is at the desired cutting height in operating
position. Gauge wheels then keep the deck
in proper position to help prevent scalping
in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on
a flat level surface.
1. Adjust mower to desired cutting height
(See "TO ADJUST MOWER CUTTING
HEIGHT" in this section of manual).
2. With mower in desired height of cut posi-
tion, gauge wheels should be assembled
so they are slightly off the ground. Install
gauge wheel in appropriate hole. Tighten
securely.
3. Repeat for all, installing gauge wheel in
same adjustment hole.
Put attachment lift lever in desired cutting
height slot.
The cutting
height range is approximately
1'* to 4". The heights are measured from
the ground to the blade tip with the engine
not running. These heights are approximate
and may vary depending upon soil condi-
tions, height of grass and types of grass
being mowed.
The average lawn should be cut to ap-
proximately 2-1/2" during the cool season
and to over 3" during hot months.
For
healthier and better looking lawns, mow
often and after moderate growth.
For best cutting performance,
grass over
6" in height shoutd be mowed twice. Make
the first cut relatively high; the second to
desired height.
12
TO OPERATE MOWER
Your tractor is equipped with an operator
presence
sensing
switch.
Any attempt
by the operator to leave the seat with the
engine running and the attachment
clutch
engaged will shut off the engine. You must
remain fully and centrally positioned in the
seat to prevent the engine from hesitating or
cutting off when operating your equipment
on rough, rolling terrain or hills.
1. Select desired height of cut with attach-
ment lift lever.
2. Start mower blades by engaging attach-
ment clutch control.
TO STOP MOWER BLADES
Disengage attachment clutch control.
_L',OAUTION:
Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector shield
(S) in place.
Advertisement
