Install Seat; Check Battery - Craftsman 917.28713 Operator's Manual

INSTALL SEAT
1. Remove bolt and flat washer securing
seat to cardboard packing and set
aside for assembly of seat to tractor.
Remove the cardboard packing and
discard.
2, Connect switch to seat.
3. Place seat on seat pan so all three (3)
bottom pads are positioned over large
slotted holes in pan.
Slot
Pad
Flat
washer
Tape
pan
Adjustment
Bolt Tab handle
pan
jJ
/ J
J
Tape
Wiring harness
CHECK BATTERY
1. Lift seat pan to raised position.
NOTE:If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps.
4. Push down on seat to engage pads in
slots and pull seat towards rear of trac-
tor.
5. Raise seat and tighten bolt securely.
6. Remove tape and discard.
7. Lower seat into operating position and
sit on seat. Press clutch/brake pedal all
the way down. If operating position is
not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle
and pull up, slide seat to desired position
and release adjustment handle.