Download Print this page

Craftsman 917.377971 Owner's Manual page 4

6.75 horsepower 21" multi-cut power propelled rotary lawn mower

Advertisement

'ere not
shipped with your mower. They are also available at most Sears retail outlets and service
centers. Most Sears stores can also order repair parts for you, when you provide the model
number of your lawn mower. Some of these accessories may not apply to your lawn mower.
LAWN MOWER
PERFORMANCE
CUPPING DEFLECTOR
FOR REAR DISCHARGE LAWN MOWERS
MULCHER KITS
STABILIZER
G SCATC,E.S
O DATCNE.S
FOR
FOR
REAR DISCHARGE
' _
SIDE DISCHARGE
LAWN MOWERS
i
LAWN MOWERS
GAS CANS
LAWN MOWER
MAINTENANCE
MUFFLERS
BUSES
AIR RLTERS
BLADE AD_RS
I
SPARK PLUGS
WHEELS
ENGINE OIL
Read these instructions and this manual in
its entirety before you attempt to assemble
or operate your new lawn mower.
IMPORTANT: This lawn mower is shipped
WITHOUT OIL OR GASOLINE
in the
engine.
Your new lawn mower has been as-
sembled at the factory with the exception
of those parts left unassemblad for
shipping purposes. To ensure safe and
proper operation of your lawn mower, all
parts and hardware you assemble must be
tightened securely. Use the correct tools
as necessary to ensure proper tightness.
All parts such as nuts, washers, bolts, etc.,
necessary to complete the assembly have
been placed in the parts bag.
TO REMOVE
LAWN MOWER
FROM
CARTON
• Remove loose parts included with
mower.
• Cut down two end corners of carton and
lay end panel down fiat.
• Remove all packing materials except
padding between upper and lower
handle and padding holding operator
presence control bar to upper handle.
• Roll lawn mower out of carton and check
carton thoroughly for additional loose
parts.
4
HOW TO SET UP YOUR LAWN
MOWER
TO UNFOLD
HANDLE
IMPORTANT:
Unfold handle carefully so
as not to pinch or damage control cables.
• Raise lower handle section to operating
position and squeeze
the bottom ends of
lower handle towards each other until
the pin in handle can be inserted into
one of the three height adjustment
holes.
• Remove protective padding, raise upper
handle section into place on lower
handle and tighten both handle knobs.
• Remove any packing material from
around control bar.

Advertisement

loading