Troubleshooting Table - Craftsman 358.350600 Instruction Manual

2.6 cu.in./42cc 2-cycle gasoline chain saw
Table of Contents

Advertisement

TROUBLESHOOTING
TABLE
WARNING: Always stop unit a nd disconnect
spark p lug b efore perform-
ing allofthe recommended
remedies below except remedies that r equire
operation
of the
unit.
TROUBLE
CAUSE
Engine will not
1. ON/STOP
switch
in
start or will run
STOP position.
only a few
2. Engine flooded.
seconds
after
starting.
3. Fuel tank empty.
4. Spark plug not firing.
5. Fuel not reaching
carburetor.
6. Carburetor
requires
adjustment.
7. None of the above.
Engine will
1. Idle speed set too high
not idle
or too low.
properly.
2. Low Speed Mixture
requires
adjustment.
3. Crankshaft
seals worn.
4. Compression
low.
5. None of the above.
Engine will not
1. Air filter dirty.
accelerate,
2. Spark plug fouled.
lacks power,
or dies under
3. Carburetor
requires
a load.
adjustment.
4. Exhaust
ports or muf-
fler outlets
plugged.
5. Compression
low.
6. Chain brake engaged.
7. None of the above.
Engine
1. Choke
partially on.
smokes
2. Fuel mixture
incorrect.
excessively.
3. Air filter dirty.
4. High Speed Mixture
requires
adjustment.
5. Crankcase
leak.
Engine runs
1. Fuel mixture
incorrect.
hot.
2. Spark
plug incorrect.
3. High Speed Mixture
set too lean.
4. Exhaust
ports or muf-
fler outlets
plugged.
5. Carbon
build-up
on
spark arresting
screen.
6. Starter housing
dirty
7. None of the above.
REMEDY
1. Move ON/STOP switch to ON.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
6.
7.
See "Difficult Starting" in the
Operation Section.
Fill tank with correct fuel mixture.
Install new spark plug.
Check for dirty fuel filter; replace.
Check for kinked or split fuel line;
repair or replace.
See "Carburetor Adjustment" in the
Service and Adjustments
Section.
Contact Sears Service (see back cover).
See "Carburetor Adjustment" in the
Service and Adjustments
Section.
See "Carburetor Adjustment" in the
Service and Adjustments
Section.
Contact Sears Service (see back cover).
Contact Sears Service (see back cover).
Contact Sears Service (see back cover).
Clean or replace air filter.
Clean or replace plug
and regap.
See "Carburetor Adjustment" in the
Service and Adjustments
Section.
Contact Sears Service (see back cover).
Contact Sears Service (see back cover).
Disengage
chain brake.
Contact Sears Service (see back cover).
Adjust choke.
Empty fuel tank and refill with
correct fuel mixture.
Clean or replace air filter.
See "Carburetor Adjustment" in the
Service and Adjustments
Section.
Contact Sears Service (see back cover).
See "Fueling Engine" in the Operation
section.
Replace with correct plug.
See "Carburetor Adjustment" in the
Service and Adjustments
Section.
Contact Sears Service (see back cover).
Clean spark arresting screen.
Clean starter housing area.
Contact Sears Service (see back cover).
2O

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents