Advertisement
STEP 8:
(SEE FIGURE 8)
IMPORTANT:
Make sure the tray is turned so that the
locking notch is at the front.
•
Assemble the tongue to the tray using two 3/8" x 1"
hex bolts, two 3/8"x 1-1/4" hex bolts, four 1/4" long
spacers, and four 3/8" nylock nuts. Tighten.
Assemble two 3/8" x 1-1/4" hex bolts, four 1/4" long
spacers and two 3/8" nylock nuts to the holes on the
other side of the slot in the tray. Tighten.
318" × 1"
318" × 1=1/4"
HEX BOLT
HEX BOLT
3/8" × 1-1/4"
HEX BOLT,
LOCKING
NOTCH
1/4" LONG
SPACER
3/8" NYLOCK NUT
FIGURE 8
STEP 9:
(SEE FIGURE 9)
Place the tray between the end plates. Temporarily
insert one 5/16" x 3/4" hex bolt into each back corner
and one of the front corners of the tray to hold end
plates together at three of the four corners.
Rotate the middle brace up against the tongue,
aligning it with the holes that are closest to the slot in
the tray. Fasten the brace to the tongue using two 3/8"
x 1" hex bolts and 3/8" nylock nuts. Do not tighten
till step 12.
318" x 1"
5116" x 314"
HEX BOLT
HEX BOLT
_,
(Temporary)
318" NYLOCK NUT
FIGURE 9
Call 1-866-576-8388
for missing parts or assembly help
7
DO NOT RETURN TO STORE
Advertisement
