Advertisement
STEP 4:
(SEE FIGURE 4)
*
Assemble a 2.38" long spacer, a 3/4" flat washer,
the middle brace, a 3/4" flat washer and a 3.90" long
spacer onto the long end of the shaft. The bent lip of
the middle brace must face the short end of the shaft.
Next assemble a double spool assembly, a 5.29" long
spacer, another double spool assembly, a 1.00" long
spacer and a 3/4" flat washer onto the shaft.
2.38" LONG
MIDDLE
SPACER
BRACE
3.90" LONG
SPACER
LONG END
OF SHAFT
3/4" FLAT
WASHER
3/4" FLAT
WASHER
5.29" LONG
SPACER
FIGURE 4
1.00" LONG
SPACER
STEP 5:
(SEE FIGURE 5)
*
Rotate the wheel bracket fastened to the middle of
the shaft so that it is pointing upward. Assemble an
end plate, a 3/4" flat washer and a second wheel
bracket onto the long end of the shaft. Point this
wheel bracket as shown in figure 5. Secure it to the
shaft using a 1/4" x 1-3/4" hex bolt and 1/4" nylock
nut. Tighten.
Repeat on short end of shaft.
MIDDLE WHEEL BRACKET
POINTING UP
1/4" x 1-3/4"
HEX BOLT
FIGURE 5
6
3/4" FLAT
WASHER
I_"NYLOCK
NUT
STEP 6:
(SEE FIGURE 6)
*
Assemble a wheel to a wheel bracket using a 1/2" x
3-1/2" hex bolt, a 1/2" jam nut and al/2" nylock jam
nut. Adjust the nuts so that the wheel is held securely
but will spin freely. Repeat on other side.
1/2" NYLOCK JAM NUT
FIGURE 6
1/2"JAM NUT
1/2" x 3-1/2"
HEX BOLT
STEP 7:
(SEE FIGURE 7)
*
Assemble the hitch bracket to the tongue using two
3/8" x 1" hex bolts and 3/8" nylock nuts. Tighten.
*
Assemble the hitch pin through the hitch bracket and
the tongue. Secure it with the hair cotter pin.
HITCH
PIN
\
318"x 1"
HEX BOLT
/
i
i
I '
S__3_"NYLOCK
NUT
HAIR COTTER PIN
FIGURE 7
Cal11-866-576-8388formissing
partsorassemblyhelp
DO NOT RETURN TO STORE
Advertisement
