To Install Battery Pack; To Remove Battery Pack; Installing/Removing Adaptors Without The Air Hose - Craftsman 315.115860 Operator's Manual

Refer t o CHARGING A COOLBATTERY P ACK fornormal
recharging o fbatteries. I f thecharger d oesnotcharge
yourbattery packundernormal c ircumstances, return
boththebattery packandcharger t o yournearest Sears
or otherqualified service center f orelectrical check.
TO INSTALLBATTERYPACK
See Figure 3.
[] Place battery pack in the handheld inflator. Align raised rib
on battery pack with groove inside handheld inflator.
CAUTION: When placing battery pack in the
handheld inflator, be sure raised rib on battery
pack aligns with groove inside handheld inflator
and latches snap into place properly. Improper
assembly of battery pack can cause damage to
internal components.
[] Make sure the latches on each side of the battery pack
snap in place and battery pack is secured in handheld
inflator before beginning operation.
TO REMOVE BATTERY PACK
See Figure 3.
[] Locate the latches on the side of the battery pack and
depress to release the battery pack from handheld inflator.
[] Remove battery pack from handheld inflator.
WARNING: Improperly attached hoses or adaptors
can become detached under pressure and cause
serious injury. Possible air leaks can cause faulty
pressure readings. Make sure all connections are
tightly secured.
INSTALLING/REMOVING ADAPTORS WNTHOUT
THE ANR HOSE
See Figure 4.
The tapered adaptor or sport ball needle can be used
without the air hose.
[] Remove battery pack from handheld inflator.
[] Loosen adaptor attachment knob slightly by turning
counterclockwise.
[] Push sport ball needle or tapered adaptor inward until
it stops.
[] Tighten adaptor attachment knob by turning clockwise.
[] To loosen, turn adaptor attachment knob counter-
clockwise and remove tapered adaptor or sport ball
needle.
LMCHES
SPORTBALL TO
NEEDLE LOOSEN
iNSTALL
TAPERED
ADAPTOR
ADAPTOR
ATTACHMENT KNOB
T0
TIGHTEN
Fig. 4
LMCNES TO
RELEASE BATTERYPACK
Fig. 3
11