Craftsman 917.271823 Owner's Manual page 15

These heights are approximate and may
vary depending upon soil conditions,
height of grass and typos of grass being
mowed.
• The average lawn should be cut to
approximately 2-1/2 inches during the
cool season and to over 3 inches
dudng hot months. For healthier and
better looking lawns, mow often and
after moderate gmwth.
• For best cutting performance, grass
over 6 inches in height should be
mowed twice. Make the first cut
relatively high; the second to desired
height.
TO ADJUST GAUGE WHEELS
Gauge wheels are pmpody adjusted
when they are slightly off the ground
when mower is at the desired cutting
height in operating position. Gauge
wheels then keep the deck in proper
position to help prevent scalping in most
terrain conditions.
NOTE: Adjust gauge wheels with tractor
on a flat level surface.
1. Adjust mower to desired cutting height
(See "TO ADJUST MOWER CU'I-FING
HEIGHT in the Operation section of
this manual).
2. With mower in desired height of cut
position, gauge wheals should be
assembled so they are slightly off the
ground. Install gauge wheel in
apprepdate hole with shoulder belt,
3/8 washer, and 3/8-16 Iooknut and
tighten securely.
3. Repeat for opposite side installing
gauge wheel in same adjustment
hole.
3/8-16 _ ._"
Loc nu,\. (
Gauge
W e,
Mounting _t_l" _(==::_ '
Bracket--_---------_.Y= _
3/8 Washe r --'="_" _"p-)_ ;
Gauge Wheel_*_/
;houfder
Boll
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt by
the operator to leave the seat with the
engine running and the attachment
clutch engaged will shut off the engine.
1. Select desired height of cut.
2. Start mower blades by engaging
attachment clutch control.
TO STOP MOWER BLADES -
disengage attachment clutch control.
_,CAUTION: Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector
shield in place.
Attachment C lutchLever
=Engaged"Position
J _ Attachen_tLitt
(( _J!_ Lever High
/_' Position
TO OPERATE ON HILLS
4qLCAUTION: Do not drive up or down
hills with slopes greater than 15° and do
not ddve across any slope.
• Choose the slowest speed before
starting up or down hills.
• Avoid stopping or changing speed on
hills.
• If slowing is necessary, move throttle
control lever to slower position.
• If stopping is absolutely necessary,
push clutch/brake pedal quickJyto
brake position and engage parking
brake.
• Move motion control lever to neutral
(N) position.
IMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is de-
pressed.
• To restart movement, slowly release
parking brake and clutch/brake pedal.
• Slowly move motion control lever to
slowest setting.
• Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission by
placing freewheel control in freewheeling
position. Free wheel control is located at
the rear drawbar of tractor.
1. Raise attachment lift to highest
position with attachment lift control.
2. Poll freewheel control out and down
into the slot and release so it is held in
the disengaged position.
15