Craftsman 917.271842 Owner's Manual page 32

TROUBLESHOOTING CHART
CAUSE CORRECTION
PROBLEM
Poor grass
discharge
Headlight(s) not
working
(if so equipped)
Ba_erywlllnot
charge
1. Engine speed too slow.
2. Travel speed too fast.
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire air
pressure.
6. Worn, bent or loose blade.
7, Buildup of grass, leaves and
trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed.
10.Improper blades used.
11. Clogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
1. Switch is "OFF".
2. Bulb(s) or lamp(s) burned out
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator
(it so equipped).
4. Faulty alternator.
Lose of drive 1.
2.
3.
Engine"backfires" 1.
whenturnlng
engine
"OFF"
i
Freewheel control in
=disengaged" position.
Motion drive belt worn,
damaged, or broken.
Air trapped in transmission
during shipment or
servicing.
1. Place throttle control in
"FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before
mowing.
4. Level mower deck.
5. Check tires for proper air
pressure.
6. Replace/sharpen blade.
Tighten blade bolt.
7. Clean underside of mower
housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge
down.
10.Replace with blades listed
in this manual.
11.Clean around mandrels to
open vent holes.
1. Turn switch "ON".
2. Replace bulb(s) or lamp(s).
3. Check/replace light switch.
4. Check wiring and connec-
tions.
5. Replace fuse.
1. Replace battery.
2. Check/clean all connec-
tions.
3. Replace regulator.
4. Replace alternator.
1, Place freewheel control in
"engaged" position.
2. Replace motion drive belt.
3. Purge transmission.
Engine throttle control not 1. Move throttle control to
set at =SLOW" "SLOW" position and allow
position for 30 seconds to idle for 30 seconds before
stopping engine, stopping engine.
i
32