Advertisement
• Keepsmall vent holes open.
• Rechargeat 6-10 amperesfor 1 hour.
NOTE:The original equipmentbattery on
your tractor is maintenancefree. Do not
attemptto open or removecaps or covers.
Adding or checking levelof electrolyteis
not necessary.
TO CLEAN
BATTERY
AND TERMINALS
Corrosion and dirt on the battery and
terminals can cause the battery to "leak"
power.
1. Disconnect BLACK battery cable first
then RED battery cable and remove
battery from tractor.
2. Rinse the battery with plain water and
dry.
3. Clean terminals and battery cable ends
with wire brush until bright.
4. Coat terminals with grease or petro-
leum jelly.
5. Reinstall battery (See "REPLACING
BATTERY" in the SERVICE AND AD-
JUSTMENTS
section of this manual).
TRANSAXLE
COOLING
Keep transaxte free from build-up of dirt
and chaff which can restrict cooling.
V-BELTS
Check V-belts for deterioration
and wear
after 100 hours of operation and replace
if necessary. The belts are not adjustable.
Replace belts if they begin to slip from
wear.
ENGINE
LUBRICATION
Only use high quality detergent oil rated
with API service classification
SF-SJ.
Se-
lect the oil's SAE viscosity grade accord-
ing to your expected operating tempera-
ture.
SAE VISCOSITY GRADES
F
-20
0
30
32
40
60
80
I00
c -io
.2;
.1;
;
_
2o
io
40
TEMPERATURE
RANGE ANTICIPATED
BEFORE
NEXT OIL CHANGE
o_ wSCcha_t4
e
Change the oil after every 50 hours of op-
eration or at least once a year if the tractor
is not used for 50 hours in one year.
Check the crankcase oil level before start-
ing the engine and after each eight (8)
hours of operation.
TO CHANGE
ENGINE
OIL
Determine
temperature
range expected
before
oil change.
All oil must meet API
service
classification
SF-SJ.
• Be sure tractor
is on level surface.
• Oil will drain more freely when warm.
• Catch
oil in a suitable
container.
1. Remove
oil fill cap/dipstick.
Be careful
not to allow dirt to enter the engine
when changing
oil.
2.
Remove
yellow
cap from end of drain
valve and install the drain tube onto the
fitting.
Oil Drain Valve
Closed
and
Locked
Position
Yellow Cap
Drain Tube
3. Unlock drain valve by pushing inward
slightly and turning counterclockwise.
4. To open, pull out on the drain valve.
5. After oil has drained completely, close
and lock the drain valve by pushing
inward and turning clockwise until the
pin is in the locked position as shown.
6. Remove the drain tube and replace the
cap onto the end of the drain valve.
7. Refill engine with oil through oil fill dip-
stick tube. Pour slowly. Do not overfill.
For approximate capacity see "PROD-
UCT SPECIFICATIONS"
section of this
manual.
8. Use gauge on oil fill cap!dipstick for
checking level. For accurate reading,
insert dipstick into the tube and push
down firmly into place before removing.
Keep oil up to, but not over, the "FULE'
line on dipstick. Push dipstick dow
firmly into the tube when finished.
AIR FILTER
Your engine will not run properly using a
dirty air filter. Clean the foam pre-cleaner
after every 25 hours of operation or every
season.
Service paper cartridge every
100 hours of operation or every season,
whichever occurs first.
Service air cleaner more often under
dusty conditions.
1. Loosen knobs and remove cover.
19
Advertisement
