Gigabyte GA-MA78GPM-UD2H User Manual page 48

Onboard LAN Function
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item
to Disabled.
SMART LAN (LAN Cable Diagnostic Function)
Start detecting at Port.....
Part1-2 Status =
Part3-6 Status =
Part4-5 Status =
Part7-8 Status =
: Move
Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN
cable. This feature will detect cabling issue and report the approximate distance to the fault or short.
Refer to the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show
Open and the Length fields show 0m, as shown in the figure above.
When LAN Cable Is Functioning Normally...
If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub,
the following message will appear:
Start detecting at Port.....
Link Detected --> 100Mbps
Cable Length= 30m
Link Detected
Cable Length
Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate
at a normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is
activated.
GA-MA78GPM-UD2H Motherboard
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Open / Length
Open / Length
Open / Length
Open / Length
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Displays transmission speed
Displays the approximate length of the attached LAN cable.
SMART LAN
= 0m
= 0m
= 0m
= 0m
F10: Save
- 48 -
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults