Gigabyte GA-MA78GPM-UD2H User Manual page 27

8) SATA2_0/1/2/3/4 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The AMD SB700 controller
supports RAID 0, RAID 1, RAID 10 and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s),"
for instructions on configuring a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 10 configuration requires at least four hard drives and the total number of hard
drives must be an even number.
9) PWR_LED (System Power LED Header)
This header can be used to connect a system power LED on the chassis to indicate system power
status. The LED is on when the system is operating. The LED keeps blinking when the system is
in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).
SATA2_4
7
1 7
SATA2_3
7 1
1 7
SATA2_2
7 1
1
- 27 -
Pin No.
1
2
3
1
4
5
6
SATA2_2
7
SATA2_0
Please connect the L-shaped end
of the SATA 3Gb/s cable to your
SATA hard drive.
Pin No.
1
2
3
System Status LED
S0
S1
S3/S4/S5
Definition
GND
TXP
TXN
GND
RXN
RXP
GND
Definition
MPD+
MPD-
MPD-
On
Blinking
Off
Hardware Installation