Gigabyte GA-MA785GM-UD2H User Manual page 27

8) SATA2_0/1/2/3/4 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device. The AMD SB710 controller supports RAID 0, RAID 1,
RAID 10, and JBOD. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions on configur-
ing a RAID array.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are to be used, the total number of hard drives must be an even number.
• A RAID 10 configuration requires at least four hard drives and the total number of hard drives
must be an even number.
9) PWR_LED (System Power LED Header)
This header can be used to connect a system power LED on the chassis to indicate system power
status. The LED is on when the system is operating. The LED keeps blinking when the system is in S1
sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).
SATA2_4
7
1
SATA2_3
SATA2_1
1
7
1
- 27 -
Pin No.
1
7
SATA2_2
SATA2_0
Please connect the L-shaped end of
the SATA 3Gb/s cable to your SATA
hard drive.
Pin No. Definition
1 MPD+
2 MPD-
3 MPD-
System Status LED
S0
S1
S3/S4/S5
Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
On
Blinking
Off
Hardware Installation