Advertisement
TROUBLESHOOTING
CHART
PROBLEM
CAUSE
CORRECTION
M_wer blades will
1. Obstruction in clutch
1. Remove obstruction,
not rotate
mechanism.
2. Worn/damaged
mower
2. Replace mower drive belt.
drive belt.
3, Frozen idler pulley,
3. Replace idler pulley.
4. Frozen blade mandrel.
4. Replace blade mandrel.
Poor grass
1. Engine speed too slow.
discharge
Headlight(s) not
working
(if so equipped)
Battery will not
charge
Engine "backfires"
when turning
engine "OFF"
2. Travel speed too fast.
3. Wet grass.
4. Mower deck not level.
5.
Low/uneven tire air
pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves
and trash under mower.
8. Mower drive belt worn.
9. Blades improperly
installed.
10.Improper blades used.
11.Clogged
mower deck vent
holes from buildup of grass,
leaves, and trash around
mandrels,
1. Switch is"OFF".
2. Bulb(s) burned out.
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator
(if so equipped).
4. Faulty alternator.
1. Engine throttle control not
set at "SLOW" position
for 30 seconds before
stopping engine.
1. Place throttle control in
"FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before
mowing.
4. Level mower deck.
5. Check tires for proper air
pressure.
6. Replace/sharpen
blade.
Tighten blade bolt.
7. Clean underside of mower
housing.
8. Replace mower drive belt.
9. Reinstall blades sharp edge
down.
10.Replace
with blades listed
in this manual.
11.Clean around mandrels to
open vent holes.
1. Turn switch "ON".
2. Replace
bulb(s).
3. Check/replace
light switch.
4. Check wiring and connec
tions.
5. Replace fuse.
1. Replace battery,
2. Check/clean
all connec
tions.
3. Replace regulator,
4, Replace alternator.
1. Move throttle control to
"SLOW" position and allow
to idle for 30 seconds befor_
stopping
engine.
32
Advertisement
