International Character Sets - Epson ActionPrinter T-750 User Manual

DIP
Table D-I. switch group 1
Switch
number Function
l - l Select condensed or normal
characters
1-2 Select slashed or unslashed zero
1-3 Select character table*
1-4 Select printer commands
1-5 Select print quality
l-6 Select international character set
l-7
1-8
In IBM printer emulation mode, a CR is added to an 1
Table D-2. DIP switch group 2
S w i t c h
number Function
2-1 1 Select page length
2-2
Select automatic sheet feeder
mode
2-3 1 Skip-over-perforation
2-4
1 Add line feed after carriage return
Note: The factory setting for all switches except l-6, l-7, and l-8 is OFF

International Character Sets

Thirteen international character sets are available in Epson mode.
Eight of these are selected by DIP switches l-6 to l-8 and the remaining
five (Japan, Norway, Denmark II, Spain II and Latin America) can be
selected with the ESC R command, which is described in the
Command Summary. For the characters available in each character set,
see Appendix B.
In IBM printer emulation mode, you can select only two character
sets; the standard character set (Table 1) and the international
character set (Table 2). You can see the differences by looking at the
IBM character tables in Appendix B. There is also a command to let
you print any of the characters in the international character set and
several additional characters. Together these form the symbol set. The
Defaults and DIP Switches
Action
Action
when ON when OFF
Condensed Normal
0 0
Graphics Italics
ESC/P
IBM printer
emulation
mode
Draft
NLQ
See Table D-3
or ESC J if this switch is OFF
Action
Action
when ON when OFF
12 inch 11 inch
Not selected
Selected
1 inch None
CR only
CR + LF
D - 3