Table of Contents
Advertisement
INSTALLING/REMOVING
cu'rrERS
See Figure 2.
•
UNPLUG YOUR TRIMMER.
WARNING:
Failure to unplug your trimmer could result in accidental
starting causing serious injury.
i
•
Place your trimmer upside down on a workbench in
order to gain easy access to spindle and collet nut.
•
Place the small end of one, of the wrenches provided on
the spindle flats. This will hold the spindle stationary.
•
Place the larger end of the other wrench provided onto
the collet nut. Rotate wrench counterclockwise
to loosen
collet nut. See Figure 2.
WARNING:
If you are changing a cutter immediately after use, be
careful not to touch the collet nut, cutter, orcoUet with your
hands or fingers. They will get burned because of the heat
buildup from cutting. Always use the wrench provided.
I
•
If installing cutter for the first time, it can be installed
once collet nut is loose. If changing cutters, cutter will
easily slip from collet after loosening collet nut.
•
The collet is machined to precision tolerances
to fit
cutters with 1/4 in. diameter shanks.
•
With your trimmer still upside down on a workbench,
insert shank of cutter into collet. The shank of your cutter
should be close to but not touching bottom of collet. This
allows for expansion when the cutter gets hot.
•
Tighten the collet nut securely by turning clockwise with
the wrench provided. See Figure 2.
WARNING:
If collet nut is not tightened securely, cutter may come out
during use, causing serious personal injury.
TO SET DEPTH OF CUT
See Figure 3.
•
UNPLUG YOUR TRIMMER.
WARNING:
Failure to unplug your trimmer could result in accidental
starting causing serious injury.
•
Loosen the wing bolt and move the base until the tip of
cutter touches the work surface. The depth of cut is
zero at this point. See Figure 3.
WRENCHON
COLLETNUT
Fig. 2
INDICATOR
(s)
DEPTHOF
/
•
Position your trimmer so that the cutter can extend
I
below the subbase for desired depth of cut setting.
•
Move the base to obtain the desired depth of cut. The
distance the cutter moves can be read on the depth
indicator scale. Each mark on the scale indicates a 1/16
in. change in depth setting. Indicator points are located
on the base.
•
Securely tighten the wing bolt.
, WARNING:
Avoid open area of trimmer base. Serious personal injury
will result from contact with a rotating cutter.
Page 8
Advertisement
Table of Contents
