Craftsman 944.362460 Owner's Manual page 17

TROUBLESHOOTING - See appropriate section in manual unless directed
:oa Sears Service Center.
PROBLEM CAUSE
Loss of power
Poorcut-
uneven
Excessive
vibration
Starter rope
hard to pull
Grass catcher
not tilling (If so
equipped)
Hard to push
lg
2.
3.
4.
5.
6.
Rear of housing or blade
dragging in heavy grass.
Cutting too much grass.
Dirty air filter.
Buildup of grass, leaves,
and trash under mower.
Too much oil in engine.
Walking speed too fast.
1. Worn, bent or loose blade.
2. Wheel heights uneven.
3. Buildup of grass, leaves
and trash under mower.
1. Worn, bent or loose blade.
2. Bent engine crankshaft.
.
.
3.
4.
,
2.
3.
1.
2.
3.
4.
Engine flywheel brake is
on when control bar is
released.
Bent engine crankshaft.
Blade adapter broken.
Blade dragging in grass.
Cutting height too low.
Lift on blade wom off.
Catcher not venting air.
Grass is too high or wheel
height is too low.
Rear of housing or blade
dragging in heavy grass.
Grass catcher too full.
Handle height position not
right for you.
CORRECTION
1. Set to "Higher Cut" position.
2. Set to "Higher Cut"
position.
3, Clean/replace air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking
speed.
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Replace blade. Tighten
blade bolt.
2. Contact a Sears or other
qualified service center.
1. Depress control bar to
upper handle before
pulling starter rope.
2. Contact a Sears or other
qualified service center.
3. Replace blade adapter.
4. Move lawn mower to cut
grass or to hard surface.
1. Raise cutting height.
2. Replace blade.
3. Clean grass catcher.
1. Raise cutting height.
2. Raise rear of mower housing
one (1) setting higher.
3. Empty grass catcher.
4. Adjust handle height to
suit.
17