Table of Contents
Advertisement
5. Slide mixing valve ontO=faUCet adapter, then push
locking ring in an upward motion to lock,
NOTE: The braided hose should be pointing in the
general direction of the area to be cleaned.
PUSH
|
LOCKING RiNG
DIRECTION OF AREA
TO BE CLEANED
6. Adjust your faucet
to cold. Check for leaks,
if
present,
tighten the area where the leak occurs.
Then, adjust your faucet between warm and hot.
Extremely
hot water could damage components of
the shampooer.
DANGER
Ordinary
tap water can be hot enough
to
quickly cause bad burns if it leaks or sprays
onto someone.
To avoid
this, make sure
your hot water heater thermostat
is set at
120°F
or less.
Ask
a plumber
or your
electric,
gas, or fuel oil supplier
for help.
Many companies provide this service at no
charge.
7. Set the bottle of shampoo in sink to avoid tipping
and remove bottle cap. (Retain cap to close bottle
after use).
NOTE: Additional
shampoo may be purchased in
your local Sears store.
8. Ptace filter end of shampoo tubing into bottle of
cleaning
solution.
Thread
aux
ary cap onto
solution bottle.
9.
Squeeze
trigger on handle and start the flow of
solution. Place floor nozzle or upholstery nozzle in
sink and squeeze tdgger until cleaning solution is
observed in the spray from the nozzle.
FILTER _.
I
iJ
il
1
4t,./FAUCET
MIXING VALVE
i
SHAMPOOTUBING
=_--_----AUXILIARYCAP
- SINK
Advertisement
Table of Contents
