Craftsman 486.252443 Owner's Manual page 5

TO iNSTALL (WHEEL)
WEIGHTS TO TILLER
NOTE: Weights are not furnished with the Tiller.
30 Ib. tractor wheel weights may be purchased to
mount to the Tiller if extra weight is required. (Refer
to the Operation section of this manual.)
• Remove two Carriage Bolts and Nuts from each Tine
Shield, located approximately 3ol/2" from the front
edge. See fig. 4.
• Place (Wheel) Weights on Tine Shield and secure
with long Bolts and Nuts furnished with the Weights.
See fig. 4.
LONG BOLT:
WHEEL
/ /
TINE
SHIELD
FIG° 4