Managing The Tape Drive - Xerox 701P21110 Guide Manual

Managing the Tape Client

Managing the tape drive

Renaming a tape
drive
3-4
In the Input Device group box on the Tape Client window, you
can initiate the following tasks to manage the tape drive from
which you are sending jobs.
If you have more than one tape drive connected to your printer,
you must select the drive that you want to use to send the job.
When the printing system is installed and your tape drives are
configured on it, the system names them "Tape 0," "Tape 1," etc.
If you want to assign a different name to a tape drive, follow
these steps:
1. On the Tape Client window, select the drive that you want to
rename from the Device menu.
2. Click Rename.... The Rename Device window opens,
displaying in the Old Name field the name of the drive that
you selected.
Figure 3-3. Rename Device window
3. In the New Name text field, enter the name you want to give
the tape drive.
4. Click OK. The Rename Device window closes, and the new
drive name is displayed on the Device menu.
NOTE: The renaming of the tape drive applies to the Tape Client
window, not to the DocuSP window.
Tape Client Job Submission Guide