Shop fox D2254-6 Instruction Sheet

Model D2254-6, D2303
Instruction Sheet
Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz
Introduction
Your new Wood Vise (Figure 1) is designed to fit on work-
benches 2 ⁄ " and thicker, but can be adapted to work-
1
4
benches down to 1 ⁄
1
2
pre-drilled in the jaw faces to attach aftermarket or shop-
built wood clamping vise jaw pads.

Specifications

Model D2254
Jaw Width 6"
Workbench
2 ⁄
1
Thickness
Maximum
5 ⁄
5
Jaw Opening
Weight 7 lbs.
Installation
1. Have another person hold the vise up against the
workbench in the desired mounting location.
Model D2256 Only: If the workbench has holes for
bench dogs, make sure the bench dog on the vise is
aligned with those holes.
Note: If the workbench is less than 2
piece of scrap wood (Figure 2) between the vise and
workbench as a shim. Cut the shim to the necessary
thickness so the vise does not protrude above the
workbench after mounting.
2. Use a pencil to mark the workbench through the four
vise mounting holes (Figure 3) so you know where to
drill pilot holes in the workbench.
3. Use a
⁄ " drill bit to drill pilot holes approximately
1
8
1 ⁄ " deep in the underside of the workbench.
1
2
COPYRIGHT © FEBRUARY, 2008 BY WOODSTOCK INTERNATIONAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT
#10497TR
Wood Vises
" thick by using a shim. Holes are
D2255 D2256
8" 6
1
" 2 ⁄ " 2
1 1
4 4
" 7 ⁄ " 7
1 3
8 4
11 lbs. 8 lbs.
THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.
D2303
⁄ " 10"
2
⁄ " 2 ⁄ "
1
4 4
⁄ " 8 ⁄ "
3
8 8
14 lbs.
Figure 2. Shim placed between workbench
⁄ " thick, use a
1
4
Model D2254 Shown
Figure 1. Shop Fox wood vise.
����
����
and vise for workbenches under 2
Mounting Holes for
Wood Screws
Figure 3. Mounting hole locations.
���������
⁄ ".
1
4
Printed in China