Notes - Panasonic Viera TC-P50C2 Operating Instructions Manual

This e quipment has b een tested and found tocomply with the limits for a nOther Class Bdigital device, pursuant toPart 15 ofthe
FCC R ules. These limits are designed toprovide reasonable protection against harmful interference inaresidential installation.
This e quipment generates, uses and can radiate radio f requency energy and, ifnot i nstalled and used inaccordance with t he
instructions, may c ause harmful interference toradio communications. However, there i sno guarantee that interference will n ot
occur inaparticular installation. Ifthis e quipment does c ause harmful interference toradio o r television reception, which can be
determined by turning the equipment off a nd o n, t he user isencouraged totrytocorrect the interference by one ormore ofthe
following measures:
•Reorient orrelocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into anoutlet onacircuit different from that towhich the receiver isconnected.
•Consult the Panasonic Service Center oran experienced radio/TV technician for h elp.
FCC Caution:
To assure continued compliance, follow the attached installation instructions and use only shielded interface cables
when connecting to peripheral devices. Any changes or modifications not expressly approved by Panasonic Corp. of
North America could void the user's authority to operate this device.
Responsible Party:
Contact Source:
emaih
Panasonic Corporation of North America
One Panasonic Way, Secaucus, NJ 07094
Panasonic Consumer Electronics Company
1-877-95-VIE RA (958-4372)
consumerproductsCo) panasonic.com
CANADIAN NOTICE:
For Model TC-P42C2, TC-P46C2, TC-P50C2
This Class B digital apparatus complies with Canadian ICES-O03.
Notes
• Do not display a still picture for a long time
This causes the image to remain on the plasma screen
("Image retention"). This is not considered a malfunction and is not covered by the warranty.
To prevent the "Image retention", the screen saver is
automatically activated after a few minutes if no signals are
sent or no operations are performed. (p. 49)
Typical still images
® Channel number and other Iogos
® Image displayed in 4:3 mode
® SD Card photo ® Video game ® Computer image
• Set up
® Do not place the unit where it's exposed to sunlight or other bright light (including reflections).
® Use of some types of fluorescent lighting may reduce the remote control's transmission range.
7