Table of Contents
Advertisement
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Installation
In this manual, "User" refers to whoever has access to the Network Camera, and
"Administrator" refers to the person who can configure the Network Camera and grant
user access to the camera.
Hardware installation
Upon powering up, the front red LED will become lighted first and then the device will go
through booting process. During the booting process, red, blue and green LEDs will be
on. After booted, the Network Camera will standby for getting IP address. After getting IP
Address, the green LED will blink every second.
The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the
Network Camera will try WLAN. During the searching and connecting process to the
wireless access point or station, the red LED of the Network Camera will flash every
second. Until the Network Camera connects to the other wireless device, the red LED
- User's Manual
Please verify that your product package contains all the
accessories listed in the foregoing Package Contents.
Depending on the user's application, an Ethernet cable
may be needed. The Ethernet cable should meet the specs
of UTP Category 5 and not exceed 100 meters in length.
Connect the power adapter jack to the Network
Camera before plugging in to the power socket. This will
reduce the risk of accidental electric shock.
- 7 -
www.vivotek.com
Advertisement
Table of Contents
