Gigabyte GA-EP41-UD3L User Manual page 42

The following fields display your hard drive specifications. If you wish to enter the parameters manually,
refer to the information on the hard drive.
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Drive A
Allows you to select the type of floppy disk drive installed in your system. If you do not install a floppy
disk drive, set this item to None. Options are: None, 360K/5.25", 1.2M/5.25", 720K/3.5", 1.44M/3.5",
2.88M/3.5".
Floppy 3 Mode Support
Allows you to specify whether the installed floppy disk drive is 3-mode floppy disk drive, a Japanese
standard floppy disk drive. Options are: Disabled (default), Drive A.
Halt On
Allows you to determine whether the system will stop for an error during the POST.
All Errors
No Errors
All, But Keyboard
All, But Diskette
All, But Disk/Key
Memory
These fields are read-only and are determined by the BIOS POST.
Base Memory
Extended Memory
Total Memory
BIOS Setup
Approximate capacity of the currently installed hard drive.
Number of cylinders.
Number of heads.
Write precompensation cylinder.
Landing zone.
Number of sectors.
Whenever the BIOS detects a non-fatal error the system boot will stop.
The system boot will not stop for any error.
The system boot will not stop for a keyboard error but stop for all other errors.
(Default)
The system boot will not stop for a floppy disk drive error but stop for all other
errors.
The system boot will not stop for a keyboard or a floppy disk drive error but it
will stop for all other errors.
Also called conventional memory. Typically, 640 KB will be reserved for the
MS-DOS operating system.
The amount of extended memory.
The total amount of memory installed on the system.
- 42 -