Sony DSLR-A390 Instruction Manual page 4

Note:
This equipment has been tested and %und
to comply with the limits lk)l- a (-lass B
digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses. and can
radiate radio frequency energy and. if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However. there is no guarantee that
interK.rence will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning tile equipment off and on. tile user
is encouraged to t W to correct tile
interference by one or morn of tile
following measures:
Reorient or relocate the receiving
antenna.
Increase file separation belween the
equipment and receiver.
Connect tile equipment into an outlet
on a circuit different from that to which
the receiver is connected.
Consult tile dealer or an experienced
radio/TV technician for help.
Tile supplied interf:.ce cable must be used
with the equipment in order to comply with
tile limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
Notice forthe customersin the
countries applyingEUDirectives
The manulacturcr of this product is Sony
Corporation. 1-7-1 Konan Minato-ku
Tokyo. 108-0075 Japan. Tile Authorized
Representative for EMC and product safety
is Sony Deutschland GmbH. Hedelfinger
Strasse 61. 70327 Stuttgart. Germany. For
any service or guarantee matters please
refer to tile addresses given in separate
service or guarantee doculnents.
This product has been tested and found
compliant with tile limits set out in tile
EMC Directive for using connection cables
shorter than 3 meters (9.8 feet).
Attention
The electromagnetic fields at the specific
frequencies may influence tile picture and
sound of this unit.
Notice
If static electricity or electromagnetism
causes data transfer to discontinue midway
(fail), restart tile application or disconnect
and connect tile communication cable
(USB, etc.) again.