Sony DSLR-A390 Instruction Manual page 16

• When the CHARGE lamp flashes fast, remove the battery pack being
charged, and then insert the same battery pack into the battery charger
securely again. When the CHARGE lamp flashes fast again, this may
indicate a battery error or that a battery pack other than the specified type
has been inserted. Check that the battery pack is the specified type. If the
battery pack is the specified type, remove the battery pack, replace it with
a new' one or another one and check if the battery charger operates
correctly. If the battery charger operates correctly, a battery error may
have occurred.
• When the CHARGE lamp flashes slowly, it indicates that the battery
charger stops charging temporarily on standby. The battery charger stops
charging and enters the standby status automatically when the
temperature is outside of the recommended operating temperature. When
the temperature gets back within the appropriate range, the battery
charger resumes charging and the CHARGE lamp lights up again. We
recommend charging the battery pack in an ambient temperature of
between 10°C to 30°C (50°F to 86°F).
Notes
• Connect the b;_tter_ charger to the nearest wall outlet (wall socket).
• When charging is finished, disconnect the power cord (mains lead) from the wall
outlet (wall socket), and remove the battery pack from the battery charger. If you
leave the charged battery pack on the charger, battery lillz may be decreased.
• Do not charge any battery pack other than the "lnfk_LITHIUM" H series battery pack
in the battery charger (supplied) with your camera. Batteries other than the specifed
kind may leak, overheat, or explode if you attempt to charge them, posing a risk of
injury from electrocution and bm'ns.
• If the battery charger is dirty, charging may not be performed successfi/lly. Clean the
battery charger with dry cloth, etc.
To use your camera abroad-- Power sources
You can use your camera and the battery charger and the AC-PWIOAM
AC Adaptor (sold separately) in any country or region where the power
supply is within 100 V to 240 V AC, 50/60 Hz,
Note
• Do not use an electronic transformer (travel converter), as this may cause a
malRmction.
16