Epson DFX 8500 Service Manual page 24

DFX-8500
1.2.12.4 Overlapping Multi-part Form
e
bindings must not be too hard. And there should not be any spill
1.2.12.5 Perforation
l
Weak horizontal and vertical perforations cause paper jams.
v The length ratio of the cut part and uncut part of perforations must be more than 3 to 1 and Less than 5
to 1 (Refer to Figure I-13.).
l
Horizontal perforations must have an uncut part in each end of the paper (Refer to Figure l-14.).
l
At the intersection of horizontal and vertical perforations, the cut part of the perforations must not cross
each other (Refer to Figure l-15.).
l
The raised part at the perforation must bs less than 1 mm when the bottom layer kept by force (Refer
to Figure l-16.).
1.2.12.6 Notes
l
Clean paper (with no folds, creases, tears) should be used (Refer to Figure l-17.).
l
The sprocket hde must be circular. The hole may have teeth (Refer to Figure l-18.).
l
The sprocket hole of each layer must not be shiied (Refer to Figure l-19.).
l
The litter of sprocket holes must be removed from the paper.
l
Paper should be fan-folded at horizontal perforations. Never use one that is not fan-folded property
(Refer to Figure l-20.).
. No hole is acceptable in the printable area.
. Paper must be tom off accurately along perforations.