Bundling The Connecting Cables - Sony BRAVIA KDL-46XBR8 Operating Instructions Manual

Anchor t heTVtotheWall
Use thehardware
listed below (not supplied):
• Two M6 x 10-12 mm anchor bolts (screw into
the top-most wall-mount holes located on the
rear of the TV)
• Rope or chain (attach to one M6 anchor bolt)
• Wall-anchor (attach to the wall stud) strong
enough to support the weight of the TV (pass
the rope through the wall-anchor, then attach
to the other M6 anchor bolt)
Anchor bolts
holes
Rope or
chain
Wall-
anchor
For KDL-70XBR7
Securing the TV to the wall with cords.
Tie !@
firmly
®
®
Thread strong cords or chains (not supplied)
through the handle on the rear side of the TV,
and tie firmly.
Secure the cords or chains to a stable place,
such as a wall or column.
• Securing the TV to the stand without securing it and
the stand to the wall provides minimum protection
against the TV toppling over. For further protection,
follow all three measures recommended above.
You can bundle the connecting cables as illustrated
below.
• Do not bundle the AC
power cord with other
connecting cables.
1 Connect the AC power cord (supplied) to the
AC IN jack of the TV.
2 Secure the AC plug holder to the display's AC
IN jack.
AC IN (power
supply input) jack
on the display
AC plug holder
(supplied)
AC power
cord
(supplied)
@ Attach the AC plug holder @ Clip on to the AC IN
to the AC power cord, jack until you hear
clicking,
• When you unplug the AC power cord, drag the holder
down by pushing both sides of the holder, then pull out
the plug.
if}
9