If you cannot find an appropriate mounting location, consult your car dealer or your nearest Sony dealer before mounting. Before Mounting • A depth of at least 49.3 mm (2 in.) is required for mounting the woofer. Keep the following...
Mounting Parts List ® M4 × 40 2.5 m (98 1/2 in./po.) ×2 Mounting example Mark the four bolt holes. Make them 3.3 mm • (%_ in.) in diameter. = 5 mm (Ih2 in. 104 mm (4 llj in Black-striped cord * White cord -- Left speaker Gray cord -- Right speaker...
Page 5
® ® ® Remove the grille net.. ® Speaker Door panel...
Page 6
Gray cord -- Right speaker I Power amplifier, etc. Press and insert the edges of the grille net. Flat mounting (installed flush with the surface of the dash) /_91 mm (3 V, in, _...
Page 7
Door p anel How to remove the grille net This speaker can be made to fit almost any type of car by removing the moun_ng tabs. Use clippers or pliers, etc. to cut or snap the mounting tabs off so that it is even with the edge of the speaker frame as illustrated.
Frequency response Mass Approx. 480 g (1 lb. 1 oz.) per speaker Design and specifications are subject to change without notice. Dimensions * Mounting depth _,e) 49.3 (2)* 16.5 (zl/a2) Unit: mm (in.) Sony@line http_/www.world.sony.com/ Sony Corporation Printed in USA...