Additional
Information"
General
setup
information
Settingthe
RF unit
When connecting
the VCR to the TV
using only the antenna cable, you must
set the RF UNIT switch on the rear of the
VCR so that the TV can receive the
correct signal from the VCR.
RF UNIT
CH3
CH4
_
r----""
m
V
f
POWER
CHANNEL +/-
1
Set the RF UNIT switch on the rear of the VCR to CH 3 or CH 4,
whichever
channel is not used in your area. If both are used, set the
switch to either channel.-
Press POWER to turn on the VCR.
2
3
Press TV/VIDEO
on the remote commander
to turn on the VIDEO
indicator in the VCR's display window.
4
Pr_s CHANNEL
+/-
to display a channel number in the display
window. Select an active channel number in your area.
5
Turn on your-TV and set it to the channel you selected in step 1
(channel
3 or 4).
The selected TV channel broadcast appears
on the TV screen. If the
channels
change when you press CHANNEL
+/-, you have made the
correct setting.
Whenever
you use the VCR, set the TV to the channel selected in step 1.
44.1 Additional
Information