Sony WEGA KV-36FV1 Operating Instructions Manual page 31

Operating a Cable Box or DBS Receiver
Programming the remote
You can program the supplied remote control
to operate a cable box or DBS receiver.
1 Press CODE SET.
2. Press DBS/CABLE (FUNCTION).
3 Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4 Press ENTER.
For more details on operating the
cable box or DBS receiver
Refer to the operating instructions that were
supplied with the equipment.
If the remote control doesn't work
• First, try repeating the setup procedures
using the other codes listed for your
equipment.
Tips "0"
• If more than one code number is listed, try
entering them one by one until you come to the
correct code for your equipment.
• Ifyouenteranewcodenumber, thecodenumber
you previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control.
In this case, use the equipment's supplied remote
control.
• Wheneveryouremovethebatteriesthecode
numbers may revert to the factory setting.
Cable box code numbers
Manufacturer Code
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. I. 201,202, 203, 204, 205, 206,
207, 208, 218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214, 215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212, 213
DBS receiver code numbers
Manufacturer
Sony
General Electric
Hitachi
Hughes
Panasonic
RCA/PROSCAN
Toshiba
Code
80I (preset code for
remote control)
802
805
804
803
802, 808
806, 807
28