Epson CPD 8882-R1 Printer Basics Manual page 55

You see vertical banding . . .
Make sure the print head nozzles are
not clogged. To clean the print
head, see page 27.
Run the Print Head Alignment
utility. See page 37 for instructions.
Make sure the paper thickness lever
is in the
0
Set the thickness lever to the
position when you print on
+
thicker paper or envelopes. You may
also need to turn off
printing in the printer software's
Advanced dialog box.
48
position, as shown below.
High Speed
Your printout is blurry or
smeared . . .
Make sure your paper isn't damp or
loaded face down (the printable side
should be loaded face up). If it's
damp, reload a new stack of paper.
Use a support sheet with special
media or try loading your media
one sheet at a time.
Make sure your paper or media
meets the specifications listed in
your electronic EPSON Stylus
COLOR 660 Reference Guide.
Run the Print Head Alignment
utility. See page 37 for instructions.
Check the paper thickness lever
position. If it's in the
your printer is set for thicker paper
or envelopes and your image may
smear. For most papers, set the
paper thickness lever to the
position, as shown to the left.
position,
+
0