Quick Reference Guide - Generac Power Systems FORD DURATEC 0F9765MNL Engine Parts Manual

3.0 Liter
ENGINE SIZE:
OIL CAPACITY: 1.0 gallons (w/filter)
scheduled maintenance kits
common reference parts
Description
oil filter (main)
fuel filter
air cleaner element
v-Belt
thermostat
thermostat Gasket
Water Pump
Starter motor
Spark Plug
additional reference parts
alternator
ignition coil
Engine Oil Recommendations
◆
The unit has been filled with "break in" engine oil
at the factory. Use a high-quality detergent oil classi-
fied "For Service CC, SD, SE or SF ." Detergent oils keep
the engine cleaner and reduce carbon deposits. Use oil
having the following SAE viscosity rating, based on the
ambient temperature range anticipated before the next
oil change:
Temperature
Above 75º f (24º C)
40º to 75º f (4.4º to 24º C)
10º to 40º f (-12º to 4.4º C)
below 10º f (-12º C)
Coolant
◆
Use a mixture of half low silicate, ethylene glycol base
antifreeze and half soft water. Use only soft water and
only low silicate antifreeze. If desired, you may add a
high quality rust inhibitor to the recommended coolant
mixture. When adding coolant, always add the recom-
mended 50-50 mixture.
do not remove the radiator pressure cap while
*
the engine is hot or serious burns from boiling
liquid or steam could result.
3.0L GAS eNGINe QUICK RefeReNCe GUIde
QUICK RefeReNCe eNGINe PARTS
Gas
FUEL: MAKE:
COOLANT CAPACITY:
Description
oil/air
–
Part number
0d5419
na
0d3488n
075885
048665
0f9225
0e9747
0f97650226
0e9868a
0f9228
oil Grade (Recommended)
SAe 30W
SAe 20W or 15W-40
SAe 10W or 15W-40
SAe 5W-30 (Synthetic) or 5W-20
ford
ENGINE P/N:
4.0 gallons
Part number
na
–
Special notes
check Bom
Serpentine
* ethylene glycol base antifreeze is poisonous.
do not use your mouth to siphon coolant from
the radiator, recovery bottle or any container.
Wash your hands thoroughly after handling.
Never store used antifreeze in an open container
because animals are attracted to the smell and
taste of antifreeze even though it is poisonous to
them.
* do not use any chromate base rust inhibitor with
ethylene glycol base antifreeze, or chromium
hydroxide ("green slime") will form and cause
overheating. engines that have been operated
with a chromate base rust inhibitor must be
chemically cleaned before adding ethylene glycol
base antifreeze. Using any high silicate anti-
freeze boosters or additives also will cause over-
heating. We also recommend that you do NoT
use any soluble oil inhibitor for this equipment.
1
0f9765
MODEL:
User notes
DANGER
—